3
CF65/75/85 series Removal and installation, gearbox
ZF 6S-850 GEARBOX
4-1
4. REMOVAL AND INSTALLATION, GEARBOX
4.1 REMOVAL AND INSTALLATION , ENTIRE GEARBOX
Removing the entire gearbox
1. Make sure there are no loose items in the
cab. Tilt the cab.
2. Disconnect the negative terminal of the
battery.
3. Remove the gearbox cable harness and
secure it.
4. Loosen the tachometer connection.
5. Remove the shift control by loosening the
torque rod bracket and the lever on the
selector shaft.
6. Remove the prop shaft and secure it so that
it does not form a hindrance in further
operations.
7. Remove the exhaust pipe between the
engine brake and the silencer.
8. Remove the clutch servo. No air or
hydraulic pipes need be removed. Secure
the servo and ensure that no one in the cab
can operate the clutch pedal as long as the
servo is not fitted.
9. Place a jack under the gearbox and remove
the bolts around the clutch housing.
10. Use the jack to pull the gearbox from the
engine and remove the gearbox.
V300407
4
5
5
ᓻ 0111
https://www.truck-manuals.net/
To Next Page
Loading...
