3
ZF 6S-850 GEARBOX
Removal and installation, gearbox CF65/75/85 series
4-8
RHD version
Removing the selector shaft oil seal
1. Mark the gearbox lever relative to the
selector shaft and remove the control lever
with the gearbox control. If necessary,
disconnect the torque rod.
2. Remove the bearing housing attachment
bolts and slide it off the selector shaft.
3. Drive the dust and oil seals out of the
bearing housing. If necessary, the selector
shaft bearing bushes now can be replaced
with special tool (DAF No. 0694818). Press
the bearing bush on the spring side 2 mm
under the edge.
Installing the selector shaft oil seal
1. Sparingly apply a liquid gasket to the oil
seal and fit it in the bearing housing using
special tool (DAF No. 0535659). Now fit the
dust seal in the bearing housing using
special tool (DAF No. 0535659).
2. Apply grease to the oil seal lips. Fit a new
O-ring to the selector shaft housing.
Fit the selector shaft housing over the
selector shaft.
3. Tighten the attachment bolts to the
specified torque and install the gearbox
control. Tighten the attachment bolts to the
specified torque. See “Technical data”.
Check that all switches function properly.
V3 00 400
5
ᓻ 0111
https://www.truck-manuals.net/
To Next Page
Loading...
