DAF CF75 Series - Removal and Installation, Gearbox

3
CF65/75/85 series Removal and installation, gearbox
EATON FS/6309A GEARBOX
3-1
3. REMOVAL AND INSTALLATION, GEARBOX
3.1 REMOVAL AND INSTALLATION , ENTIRE GEARBOX
Removing the entire gearbox
1. Make sure there are no loose items in the
cab. Tilt the cab.
2. Disconnect the battery negative terminal.
3. Remove the attachment bolts of the prop
shaft flange and remove the prop shaft.
4. Remove the attachment bolt from the
exhaust bracket on the gearbox.
5. Remove the clamping straps of the
intermediate pipe and remove the same.
6. Remove the end of the exhaust by
removing the clamping strap and the
attachment bolt of the rubber suspension
point at the end of the exhaust.
7. Remove the attachment bolts from the
clutch cylinder and remove the clutch
cylinder.
8. Mark the electrical connectors and
disconnect them.
9. Remove the compressor pipe bracket.
10. Remove the shift control.
11. Mark the various air pipes and remove
them.
12. Support the gearbox and remove the
attachment bolts around it.
13. Use the jack to pull the gearbox from the
engine and remove the gearbox.
8
ᓻ 0111
https://www.truck-manuals.net/