3
CF65/75/85 series Description of components
AUTOMATIC GEARBOXES
2-3
Faults
If the oil level indicator cannot give the correct oil
level, one of the following codes will appear in
the display.
OL - 50 Engine speed too low
OL - 59 Engine speed too high
OL - 65 Gearbox is not in neutral
OL - 70 Gearbox oil temperature too low
OL - 79 Gearbox oil temperature too high
OL - 89 Output shaft is not stationary
(handbrake)
OL - 95 Oil level indicator is defective
The oil level reading function can be left by
pressing “D”, “N” or “R”.
Note: the function cannot be left by pressing the
arrow keys again, as this prompts the diagnostic
code reading function. All diagnostic codes are
preceded by the letter D followed by a figure
between 1 and 5. In this function, important fault
codes could be deleted from the memory by an
unqualified user.
9
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
