DAF CF75 Series - Inspection and Adjustment

3
CF65/75/85 series Inspection and adjustment
AUTOMATIC GEARBOXES
3-1
3. INSPECTION AND ADJUSTMENT
3.1 INSPECTION, OIL LEVEL
Inspection, cold oil level
1. Place the vehicle on a level surface.
2. Make sure that the gearbox is in neutral and
allow the engine to run for several minutes.
3. Operate the service brake, put the gearbox
in D, then in N, and finally put the gearbox
in R. The purpose of this is to fill the
hydraulic system.
4. Switch the gearbox to the park position and
release the service brake.
5. Remove the dipstick when the engine is
idling and wipe it clean with a lint-free cloth.
Note:
To take the dipstick out of the holder, the
sealing cap must be held tightly and the
dipstick turned anti-clockwise.
6. Put the dipstick back.
7. Remove the dipstick and check the oil level.
The oil level must be between the “Cold
add” and the “Cold full” marks.
8. Clean the dipstick with a lint-free cloth and
put it back.
9. Remove the dipstick and check the oil level.
10. Oil needs to be added when the oil level is
below the “Cold add” mark.
11. Now check the oil level in the gearbox at
operating temperature.
HOT
FULL
COLD
FULL
HOT
ADD
COLD
ADD
W 3 03 099
ᓻ 200337
9
https://www.truck-manuals.net/