3
CF65/75/85 series Removal and installation
AUTOMATIC GEARBOXES
4-5
4.3 REMOVAL AND INSTALLATION, OIL FILTERS
Removing the oil filters
1. Remove the attachment bolts from the filter
covers (2) and take the filter covers off.
Collect any oil flowing out of the system.
2. Remove the oil filters from the oil sump.
3. Remove the various O-rings from the filter
covers.
4. If a gasket has been used, remove the
gasket remnants from the filter covers and
the contact surfaces.
Installing the oil filters
1. Lightly lubricate the new O-rings with clean
gearbox oil and fit the various O-rings on
the filter covers.
Note:
Compare the new O-rings with the old
O-rings to ensure that the correct O-rings
are being used.
2. If a gasket has been used, fit a new gasket
on the filter cover.
3. Lightly lubricate the rubber inner ring of the
oil filters with clean gearbox oil and fit the oil
filters on the filter covers.
4. Carefully position the filter covers and oil
filters on the gearbox and tighten the
attachment bolts to the specified torque.
See “Technical data”.
5. Check the oil level. See “Inspection and
adjustment”.
V300371
2
1
9
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
