3
CLUTCH
Description of components CF65/75/85 series
3-8
3.5 AUTOMATICALLY ADJUSTING CLUTCH RELEASE ASSEMBLY
Automatically adjusting clutch release
assembly
The clutch can be fitted with an automatically
adjusting clutch release assembly. The
automatically adjusting clutch release assembly
is used in both the push and pull clutch types.
The automatic assembly is always combined
withaclutchplatewithaclearanceof5mmfor
lining wear.
This is due to the fact that the lining material is
bonded to the clutch plate.
A conventional clutch has a lining wear
clearance of 3 mm, as the lining material is
riveted to the clutch plate. The increase in lining
wear clearance extends the service life of the
clutch.
With a conventional clutch, wear of the clutch
plate causes the rest position of the diaphragm
spring to change.
The clutch release assembly automatically
compensates for the rest position of the
diaphragm spring as the clutch plate wears.
Disadvantages such as a change in the contact
pressure of the assembly and an increase in the
force required to operate the clutch are avoided.
V300487
4
8
3
2
7
5
10
6
1
9
10
10
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
