3
CLUTCH
Removal and installation CF65/75/85 series
5-4
5.3 REMOVAL AND INSTALLATION, PULL-TYPE CLUTCH THRUST BEARING
Removing the pull-type clutch thrust bearing
1. Remove the gearbox.
2. Remove the thrust bearing from the clutch
release assembly by releasing the retaining
clip (A) from the clutch release assembly.
Installing the pull-type clutch thrust bearing
In the case of thrust bearings with a
plastic coating, no grease should be
used on the gearbox front cover.
The grease will attack the plastic
coating and shorten the service life
of the thrust bearing.
The thrust bearing chamber has
been greased for the full service
life.
1. Apply a little grease to the pressure
surfaces of the release fork and the thrust
washer.
2. Fit the thrust bearing, with the lip pointing
up, dry onto the gearbox front cover.
3. Move the clutch lever, causing the thrust
bearing to engage behind the rolls of the
clutch lever.
Note:
Before fitting the gearbox, check whether
the retaining clip in the clutch release
assembly has been locked.
V300059
B
A
B
V300123
10
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
