3
CLUTCH
Removal and installation CF65/75/85 series
5-12
Note:
If you want to disassemble the entire clutch
assembly, always loosen the attachment
bolt (1) of the stop plate (2) first before
removing the clutch release assembly.
If you do not loosen the attachment bolt (1)
of the stop plate (2) before removing the
clutch release assembly, the stop spring (3)
will be deformed.
5. Fully loosen the attachment bolt (1) of the
stop plate (2).
6. Evenly remove the remaining attachment
bolts from the clutch release assembly.
7. Remove the clutch release assembly by
sliding it off the four studs.
8. Remove the clutch plate with the
dummy input shaft.
Installation of an existing automatically
adjusting clutch release assembly/clutch
plate
1. Apply a little grease to the input shaft and
check the movement of the clutch plate on
the splines of the input shaft.
2. Use a dummy input shaft to position the
clutch plate against the flywheel.
3. Install four studs in the flywheel, distributed
evenly around the circumference.
V300473
1
V300474
1
2
3
10
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
