3
CF65/75/85 series Removal and installation
CLUTCH
5-17
Installing the main cylinder
1. Check the dust cover for wear and replace if
necessary.
2. Fit the main cylinder together with the pipe
to the reservoir.
3. Fit the clutch pipe.
4. Fit the main cylinder attachment bolts to the
bracket and tighten them.
5. Fit the dust cover in the thrust pin circlip.
6. Fit the clutch pedal attachment bolt and the
main cylinder.
7. Fit the clutch spring onto the clutch pedal.
8. Fit the clutch pipe clamping bracket bolt
underneath the main cylinder.
9. Fill the clutch system. See “Draining and
filling”.
10. Adjust the clutch pedal. See “Inspection and
adjustment”.
11. Bleed the clutch system. See “Bleeding the
clutch system”.
10
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
