©
200515 4-3
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΛΦ45/55 series
5
4.3 REMOVAL AND INSTALLATION, LUBRICATING OIL FILTER
To prevent skin injury, avoid
unnecessary contact with the
drained lubricating oil.
Be careful when changing the oil.
Hot oil may cause serious injuries.
Removing the lubricating oil filter
1. Place a tray beneath the lubricating oil filter.
2. Clean the area surrounding the filter element
if this is very dirty.
3. Remove the filter element by turning it anti-
clockwise. Collect the oil that comes out.
4. Remove the O-ring if it has not been
removed already.
Installing the lubricating oil filter
1. Lightly oil the filter element sealing ring.
2. Fill the filter element with clean oil. Use the
specified oil.
3. Fit the filter element onto the housing.
Tighten the filter element until the sealing
ring abuts. Tighten the filter element a further
• to 1 turn by hand.
4. Run the engine for a short time and check
that the lubricating oil filter is correctly
sealed.
5. Check the oil level and correct if necessary.
Use the specified oil.
}
}
G0 00 207
To Next Page
Loading...
Need help?
General
