User’s Manual
257
More Setting
Show Message: Select the
checkbox to enable a pop-
up message in your local host PC.
Buzzer: Select the checkbox to activate a buzzer noise at the Device.
Video Matrix: Select the checkbox to enable the function. When an
alarm event occurs, the video output port ou
configured in "
Main Menu > DISPLAY > Tour
."
Not all models support this function.
Send Email:
Enable the system to send an email notification when an
alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > Email
.
Log: Select the checkbox to enable the Device to record a local alarm
log.
Extra screen: Select the checkbox to enable the function. When an
alarm event occurs, the extra screen outputs the settings configured
in
Main Menu > DISPLAY > Tour > Sub Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Click Save to save the settings.
5.12.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
On the home page, select IoT > Management > Temperature/Humidity.
Temperature/Humidity
To Next Page
Loading...
Need help?
General
