Dahua Technology DH-XVR1B16H-I User Manual

User’s Manual
168
Disk
Configure the settings for the HDD event.
Table 5-33 HDD event settings
Parameter
Description
Event Type
In the
Event Type
list, select
No Disk
,
Disk Error
, or
Low Space
as the event
type.
Enable Enable or disable the HDD event detection function.
Alarm-out Port
Click
Setting
to display setting page.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the external
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and the
default value is 10 seconds.
Show Message
Select the
Show Message
checkbox to enable a pop-up message in your local
host PC.
Report Alarm
Select the
Report Alarm
checkbox to enable the system to upload the alarm
signal to the network (including alarm center) when an alarm event occurs.
Send Email
Select the
Send Email
checkbox
to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu >
NETWORK > Email
.
Buzzer Select the checkbox to activate a buzzer noise at the Device.

Dahua Technology DH-XVR1B16H-I Specifications

General

Brand	Dahua Technology
Model	DH-XVR1B16H-I
Category	DVR
Language	English