19
6. There are two options for connecting the camera via the injector to your router –
hardwired or by WiFi.
If the injector can be located near the router, then plug the other end of the short
Ethernet cable into an unused router port.
If the camera and injector will be used in a location remote from the router and
AC power is available at that location, then a WiFi Extender may be used to
provide a wireless connection from the injector to the router. As shown below,
plug the short cable into the Extender and the Extender into a wall outlet. Plug
the injector’s power cord into the AC outlet as well. The Extender should have
been setup previously to communicate with the router per its manufacturer’s
instructions.
7. If the Extender and Injector are outside, be sure that they are protected from
moisture. The camera assembly is waterproof but the Extender and Injector are
not.
To Next Page
Loading...
