5
Figure 2-4
Drill holes according to the positions in Figure 2-3, and install expansion pipes into 步骤1
holes.
Install the bracket. 步骤2
If there is a concealed mount, fix the bracket onto concealed mount with screw A.
Without the concealed mount or good fixation, fix the bracket onto the wall directly
with screw B. Before fixing, embed expansion pipes at corresponding positions of
the wall.
Hang the device onto the hook of the bracket. 步骤3
Insert screws from the device bottom, fasten the bracket and complete installation. 步骤4
2.4 Panel and Port
The device is shown in Figure 2-5, Figure 2-6 and Figure 2-7. Ports of rear panel are described
in Table 2-2.
To Next Page
Loading...
