Set attendance period. When the period between Check In and Check
Out meets this period, it is a normal attendance; otherwise, it is an
exception attendance. The system supports two periods.
If two periods are set, they are regarded to be normal attendance
when both period 1 and period 2 carry out normal Check In and
Check Out.
Set overtime period. If period between overtime check-in and
check-out meets the set period, it is regarded to be overtime period.
Overtime check-in is valid only if the card is swiped between off-duty
time and overtime check-in time of “Period 1” or “Period 2”.
The range of check-in time later than on-duty time. For example,
when on-duty time is 8:00, if “Late-in Allowed” time is set to be “5”
minutes, it is regarded to be late if you check in after 8:05.
The range of check-out time earlier than off-duty time. For example,
when off-duty time is 17:00, if “Early-out Allowed” time is set to be “5”
minutes, it is regarded to be early-out if you check out before 16:55.
Table 3-4
Press . The screen prompts “Do you want to save settings?” 步骤3
Press [Yes] to complete shift config. 步骤4
3.7.1.2 Shift Import
Before importing shift table, please ensure that USB disk has been inserted. Please don’t pull
out USB disk or execute other operations during uploading; otherwise, uploading will fail, even
the device cannot work normally.
Update the corresponding file and store it in USB disk. 步骤1
Select “Attendance > Shift Setting > Shift Import”. 步骤2
The screen prompts “Are you sure to import?”
Press [Yes] to import. 步骤3
It is suggested that files should be exported first and used as import template.
3.7.1.3 Shift Export
Before downloading shift table, please ensure that USB disk has been inserted. Please don’t
To Next Page
Loading...
