Local Configurations 182
Select the Show Message check box to enable a pop-up message
in your local host PC.
Select the Alarm Upload check box to enable the system to
upload the alarm signal to the network (including alarm center)
when an alarm event occurs.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL.
Select the channel(s) that you want to record. The selected
channel(s) starts recording after an alarm event occurs.
The recording for intelligence event and auto recording function
must be enabled. For details, see "5.1.4.9 Configuring Recorded
Video Storage Schedule" and "5.9.1 Enabling Record Control."
Click Setting to display the PTZ interface.
Enable PTZ linkage actions, such as selecting the preset that you
want to be called when an alarm event occurs.
Face Detect can only link PTZ preset.
Set a length of time for the Device to delay turning off recording
after the alarm is cancelled. The value ranges from 10 seconds to
300 seconds.
Select the Tour check box to enable a tour of the selected
channels.
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are
configured:
The snapshot function is enabled for motion detect alarms in Main
Menu > STORAGE > SCHEDULE > Snapshot.
Select Main Menu > CAMERA > ENCODE > Snapshot, in the
Mode list, select Human Face.
Select the check box to enable the function. When an alarm event
occurs, the extra screen outputs the settings configured in Main
Menu > DISPLAY > TOUR > Extra Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm
log.
To Next Page
Loading...
Need help?
General