Alarm Control Panel Installer Manual
17
Installation 1.7
The Control Panel supports wall-mounting installation.
Control Panel installation Figure 1-8
Unpack the box and take out the expansion bolts and self-tapping screws. Step 1
Drill screw holes on the mounting surface according to the dimensions as shown in Figure 1-8. Step 2
Insert expansion bolts into the drilled screw holes, and then put in and fasten the self-tapping Step 3
screws (leave the middle self-tapping screw unfastened).
Hang the Control Panel to the screws and then fasten the middle self-tapping screw. Step 4
To Next Page
Loading...
