Alarm Control Panel Installer Manual
19
Access Codes
TECHNICIAN: 1961
Supervisor User: 1234
Access is required for Arming: Yes
Network
Default IP Address: 192.168.1.108
Others
2G/4G is enabled by default
P2P is disabled by default. The DMSS app cannot access the Control Panel.
REMOTE CONF is ON by default. The Alarm Configuration Tool can connect to the Control Panel.
Lead-acid Battery 1.12
1.12.1 Protection for Battery Over-Discharge
When the power supply is not from main power but from the battery, the Control Panel automatically turns
off when the battery is consumed up to 10.8V. Before the main power restarts supplying power, the Control
Panel will not repeatedly reboot because the rebooting will cause damage to the battery due to
over-discharging.
1.12.2 About the Battery Voltage Status
The lower voltage refers to the situation when the battery voltage is lower than 11.8V. When the battery is
full, the voltage is 13.8V.
To Next Page
Loading...
