Alarm Control Panel Installer Manual
71
DIGITAL FORMAT 1.39
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
DIGITAL FORMAT menu. See Figure 1-39.
Digital format Figure 1-39
Press to enter the programming mode. Step 2
Configure the programming settings. See Table 1-35. Step 3
Take Event No.001 as an example. See Figure 1-40.
Periodic test Figure 1-40
T represents telephone number. To select which telephone number to be linked, on this interface,
press , the telephone number linkage setting interface is shown. See Figure 1-41.
PSTN TEL1, PSTN TEL2, PSTN TEL3: Three telephone numbers mentioned in Monitor
Station menu.
TRUE: Links this telephone number
FALSE: Does not link this telephone number.
Telephone number linkage Figure 1-41
Table 1-35 Digital format setting
To Next Page
Loading...
