Figure 3-61
Please refer to the following sheet for detailed information.
It is to set device name.
When you are using one remote control to manage multiple devices,
you can give a serial numbers to the device.
Before the operation, please make sure you have clicked address
button on the remote control and input a number for current device.
You can select the language from the dropdown list.
Please note the device needs to reboot to get the modification
activated.
This is to display video standard such as PAL.
Here is for you to select working mode when hard disk is full. There
are two options: stop recording or rewrite.
If current working HDD is overwritten or the current HDD is full
while the next HDD is no empty, then system stops recording,
If the current HDD is full and then next HDD is not empty, then
system overwrites the previous files.
Here is for you to specify record duration.
3.6.4.2.2 Date&Time
The date and time interface is shown as in Figure 3-62.
To Next Page
Loading...