Daihatsu CB-23 - Camshaft (CB-23 & CB-61 Engines)

IN-VEHICLE SERVICE
2. Install the woodruff key. Convex
3. Install the crankshaft timing oelt pulley flange.
Frange
NOTE:
Ensure that the flanges are installed only in the correct
pulley
direction.
4. Perform the timing belt tensioner installation and the
following operations described in the section under
"ln-
stallation of Timing Belt & Water Pump." As for the
contents of these cperations, see the section under
"Timing Belt
& Water Pump."
I 1
Fig. 4-20 +~p(lvl-040~6
CAMSHAm (CB-23 & CB-61 Engines)
REMOVAL
1. After the operations up to the timing belt removal in the
section under "Removal of Timing Belt
& Water Pump"
have been completed, proceed to this operation of "Cam-
shaft Removal."
2. Remove the surge tank. (CB-61 engine only)
3. Remove the intake pipe. (CB-61 engine oniy)
4. Remove the air cleaner assembly. (CB-23 engine only)
5. Remove the resistive cords.
6. Remove the cylinder head cover.
7. Remove the distributor and distributor hcusing.
8. Remove the camshaft timing belt pulley.
NOTE:
During the timing belt pulley removal, the rotation of the
camshaft can be prevented by inserting a screwdriver
through
the opening of the pulley.
9. Slacken the attaching screws of the valve rocker arm
10. Remove the camshaft.
INSTALLATION
Reverse the removal procedure to install the camshaft.
'NM-04028
Fig. 4-21 WM-3401-