Daihatsu CB-80 - Crankshaft Oil Seal

IN-VEHICLE SERVICE
lnstall the cylinder head cover. (CB-80 engine only)
14. lnstall the bracket (surge tank
& cylinder head cover). (CB-80 engine only)
15. lnstall the water pump pulley.
16. lnstall the V-belt.
17. lnstall the engine mounting bracket. Remove the jack supporting the oil pan.
18. Install the air cleaner and hose. (C8-61 & CB-80 engines only)
19. Fill cooling water.
CRANKSHAW OIL SEAL
REMOVAL
1. After the operations up to the timing belt removal in the
section under "Removal of Timing Belt
& Water Pump"
have been completed, proceed to this operation of
"Crankshaft Oil Seal Removal."
L. Remove the crankshaft timing belt pulley.
NOTE:
If any difficulty should be encountered in removing the
crankshaft timing belt pulley, screw-in bolts into the
threaded holes provided in the side of the pulley.
3. Remove the crankshaft timing belt pulley flange
4. Remove the woodruff key.
5. Removal of crankshaft oil seal
Remove the oil seal, using the following SST.
SST: 09223-87702-000
(1) With the oil seal remover & repiacer @ placed against
the oil
seai, drive a drift into the oil seal so as to make
a hole.
(2) Thread a tapping screw into the thus-produced hoie in
the oil seal.
(3) Screw the puller @ so as to remove the oil seal.
I 1
Fig. 4-17 wM-04023
Fig. 4-1 8 WM-04024
INSTALLATION
1. lnstall the new crankshaft oil seal.
SST: 09223-87702-000
(1) Apply engine oil to the lip section of the oil seal.
(2) Place the oil seal remover & replacer @) against the oil
seal.
(3) Place the crankshaft attaching bolt (2) against the
remover & replacer @. Then, proceed to install the oil
seal into position by turning the crankshaft attaching
Oil seal remover &
Crankshaft attaching
bolt @
bolt @. Fig. 4-19 WM-04025
WWW.PlanDeGraissage.Org