Daikin Altherma ETBH16DA6V User Manual

Installation manual
Daikin Altherma 3 H HT W
English
Installation manual
Daikin Altherma 3 H HT W
ETBH16DA6V
ETBH16DA9W
ETBX16DA6V
ETBX16DA9W
https://daikintechnicaldatahub.eu

Daikin Altherma ETBH16DA6V Specifications

General

Brand	Daikin
Model	Altherma ETBH16DA6V
Category	Heat Pump
Language	English

Summary

Unit installation

3.1 Preparing the installation site

3.3 Mounting the indoor unit

Piping installation

4.1 Preparing water piping

4.2 Connecting water piping

Steps for connecting the water piping to the indoor unit.

4.2.3 To protect the water circuit against freezing

Methods to protect the water circuit from freezing, using glycol or valves.

Electrical installation

5.2 Guidelines when connecting the electrical wiring

5.3 Connections to the indoor unit

Detailed steps for connecting various electrical components to the indoor unit.

5.3.1 To connect the main power supply

Connecting the main power supply to the indoor unit.

5.3.2 To connect the backup heater power supply

Connecting the backup heater power supply to the indoor unit.

5.3.10 To connect the safety thermostat (normally closed contact)

Configuration

6.1 Overview: Configuration

6.2 Configuration wizard

Guides through initial system setup via the user interface.

6.2.5 Configuration wizard: Main zone

6.3 Weather-dependent curve

Commissioning

7.1 Checklist before commissioning

Pre-commissioning checks before powering up the unit.

7.2 Checklist during commissioning

Checks to perform during the commissioning process.

7.2.1 To check the minimum flow rate

Verifying the minimum flow rate for proper operation.

7.2.2 To perform an air purge

Procedure for purging air from the system.

7.2.4 To perform an actuator test run

Testing the operation of various unit actuators.

Hand-over to the user