What does error code UA mean on Daikin Air Conditioner?
Daikin Air Conditioner error code UA can be caused by: * The indoor unit refrigerant type is not compatible with the outdoor unit: Change the system layout and remove the incompatible indoor unit from the system. * The outdoor unit is not compatible with the self-cleaning panel (up to VRVII): Mount a standard decoration panel.
What does error code UE mean on Daikin BRYQ-A Air Conditioner?
Daikin Air Conditioner error code UE indicates a communication error with the central control device. Check the communication from the indoor unit to central control. Verify the existing group number set on the indoor unit and the registered group number in the central control.
What to do for Daikin BRYQ-A Air Conditioner error code A0?
If your Daikin Air Conditioner displays error code A0, it may indicate a fault board. Check setting 22-1-3: T1-T2 NC. If correct, it indicates an indoor board fault.
What could cause a Daikin BRYQ-A Air Conditioner to display error code A1?
If your Daikin Air Conditioner is showing error code A1, the cause is a fault in the Eeprom. The suggested solution is to replace the board.
What should I do if my Daikin BRYQ-A is showing error code A9?
If your Daikin Air Conditioner shows error code A9, it indicates an EV (expansion valve) motor fault. This could be due to: * **EV motor fault detection:** Check the signal board to the expansion valve. * **EV body leakage:** Check the temperature coil sensor at the closed EV cooling other indoor units.
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Weight | 9 kg |
| Outdoor Unit Noise Level | 49 dB |
| Noise Level (Outdoor) | 49 dB |
Records changes and updates made to the service manual over time.
Explains the concept and overall layout of the VRV4 heat recovery system.
Provides guidance on navigating and effectively utilizing the manual's content.
Instructions for accessing malfunction codes and operational data via remote controllers.
A comprehensive guide to diagnosing and resolving specific error codes encountered.
Accessing and configuring field settings using wireless remote controllers.
Accessing and configuring field settings using BRC2/3E52 wired remote controllers.
Accessing and configuring field settings using BRC1D51/52 wired remote controllers.
Accessing and configuring field settings using BRC1E51 wired remote controllers.
Accessing and configuring field settings using BRC1E52 wired remote controllers.
Common field settings applicable across most indoor unit models.
Procedures for performing factory resets and understanding default configurations.
Table detailing default field settings for various indoor unit models.
To Next Page