1-9
English
Wires Installation
Figure A
Figure A and Figure B shows the location of cover wire in indoor unit.
Steps to install power supply wires and wires from outdoor unit.
Remove wire cover by removing 2 screws as shown in Figure C.
Wires will go through the hole as shown in Figure D and E respectively without crossing the height of the hole.
After that, wire cover will be assembled back to close the wire.
1.
2.
3.
Figure B Figure C
Figure D Figure E
1 IM-5CKE-0912(0)DAIKIN-EN.indd 91 IM-5CKE-0912(0)DAIKIN-EN.indd 9 9/28/12 2:04:17 PM9/28/12 2:04:17 PM
To Next Page
Loading...
