ESIE05-04 Wiring Diagrams
Part 1 – System Outline 1–77
A1P Printed circuit board BS4 Temperature setting button up
A3P Printed circuit board BS9 Temperature setting button down
C1R Capacitor (Fan) BS6 Operation mode selector button
F1T Thermal fuse (M1F embedded) BS7 Timer ON/OFF button
HAP Light emitting diode (Service monitor-green) BS12 Inspection/test operation button
K1F Magnetic contactor (M1F) BS14 Filter sign reset button
M1F Motor (Fan) H1P Light emitting diode (Service monitor-red)
R1T Thermistor (Air) LCD Liquid cristal display
R2T Thermistor (Coil) SS1 Selector switch (Main/sub)
RyF1 Magnetic relay (Fan)
SS1 Selector switch (Emergency) Adaptor for wiring
T1R Transformer (230V/21.8V) RyC, RyF Magnetic relay
X1M Terminal strip
RC Signal receiver circuit Connector for optional parts
TC Signal transmission circuit X60A, X61A Connector (Interface adaptor for Sky Air/US
series)
Wired remote controller X33A Connector (Adaptor for wiring)
BS1 ON/OFF button X35A Connector (Group control adaptor)
BS2 Timer mode start/stop button X40A Connector (Remote ON/OFF, Forced OFF)
BS3, BS8 Programming time button
To Next Page
Loading...
