What to do if my Daikin FT35FV1M unit does not operate?
If your Daikin Air Conditioner unit is not operating, first check the power supply, ensuring there is no power failure or blown fuse. Next, verify that the power plug is securely connected. Also, check the delay timer settings to ensure they are correct. If the problem continues after these checks, it is recommended to contact the air conditioner unit installer.
How to increase air flow in my Daikin FT35FV1M?
If the airflow from your Daikin Air Conditioner is too low, start by cleaning or replacing the air filter. Ensure all doors and windows are closed to prevent drafts. Check for and clear any clogs in the air suction and discharge. Finally, adjust the regulated temperature to a higher setting.
How to get rid of bad odor from Daikin Air Conditioner?
If your Daikin Air Conditioner has a bad odor, it may be caused by particles like cigarettes, smoke, or perfume adhered to the coil. Clean the coil to remove these odors.
Why is there condensation on my Daikin Air Conditioner?
Condensation on the front air grille of your Daikin Air Conditioner indoor unit is typically due to air humidity after prolonged operation. To resolve this, increase the temperature setting and operate the unit at a high fan speed.
What is the reason for hissing sound from Daikin FT35FV1M?
It is normal to hear a hissing sound from your Daikin Air Conditioner during operation, which is caused by refrigerant fluid flowing into the evaporator coil.
Critical safety warnings for installation and operation of the air conditioner unit.
Important precautions to prevent damage or hazards during installation and operation.
Specifies required space around the outdoor unit for proper airflow and access.
Covers routing pipes, mounting the unit, and water drainage setup for the indoor unit.
Instructions for securely installing the wall mounting plate for the indoor unit.
Guidelines on refrigerant pipe length limits, elevation, and connection procedures.
Electrical connection details for specific indoor unit models (FT20-35FV1M).
Electrical connection details for specific indoor unit models (FT50/60FV1M9).
Procedures for system purging, refrigerant charging, and operation.
Explains IR signal reception and LED status lights on the unit.
Details LED signals for normal operation and error conditions.
Covers Dry Mode, Air Flow Control, and Fan Speed settings.
Explains frost issues and standard operating temperature ranges.
Describes the O2 Therapy feature and auto re-start function.
Guidelines for cleaning filters and the unit.
Steps for cleaning the blower assembly of the air conditioner.
Procedures for preparing the unit for extended periods of non-use.
General| Category | Air Conditioner |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Dimensions (W x H x D) | 770 x 285 x 223 mm |
| Outdoor Unit Dimensions (W x H x D) | 658 x 550 x 275 mm |
To Next Page
