Daikin FTXA20C2V1BW - Components: Wireless Remote Control; To Operate the Wireless Remote Control; To Mount the Wireless Remote Control Holder; To Insert the Batteries

4 Before operation
Operation manual
5
CTXA-C(W)(B)(S) + FTXA-C(W)(B)(S)
Daikin room air conditioner
3P728539-1 – 2023.05
▪ Direct sunlight. Do NOT expose the wireless remote control to
direct sunlight.
▪ Dust. Dust on the signal transmitter or receiver will reduce
sensitivity. Wipe off dust with a soft cloth.
▪ Fluorescent lights. Signal communication might be disabled if
fluorescent lamps are in the room. In that case, contact your
installer.
▪ Other appliances. If the wireless remote control signals operate
other appliances, move the other appliances, or contact your
installer.
▪ Curtains. Make sure that curtains or other objects do NOT block
the signal between the unit and the wireless remote control.
NOTICE
▪ Do NOT drop the wireless remote control.
▪ Do NOT let the wireless remote control get wet.
3.2.1 Components: Wireless remote control
Menu (push 2sec)
Panel (push 2sec)
d
a
g
m
h
c
b
n
l
f
e
i
j
k
p
o
a Signal transmitter
b LCD display
c Temperature adjustment button
d ON/OFF button
e Vertical swing and menu (push 2 seconds) button
f Horizontal swing button
g Comfort airflow and Intelligent eye operation button
h Select button
i Clock and open panel (push 2 seconds) button
j OFF/ON timer operation buttons
k Weekly timer operation buttons
l Flash Streamer (air cleaning) operation button
m Econo and Outdoor unit quiet operation button
n Mode button
o Powerful button
p Fan button
INFORMATION
Use (hold for 2seconds) to open the front panel when
you clean the air filters. See "7.4 To open the front
panel"[416].
3.2.2 To operate the wireless remote control
a
≥500
(mm)
a Infrared signal receiver
Note: Make sure that there are no obstacles within 500mm under
the infrared signal receiver. They may influence reception
performance of the wireless remote control.
1 Aim the signal transmitter at the infrared signal receiver on the
indoor unit (maximum distance for communication is 7m).
Result: When the indoor unit receives a signal from the wireless
remote control, you will hear a sound:
Sound Description
Beep-beep Operation starts.
Beep Setting changes.
Long beep Operation stops.
4 Before operation
4.1 To mount the wireless remote
control holder
cba
2×
a Wireless remote control
b Screws (field supply)
c Wireless remote control holder
1 Choose a place where the signals reach the unit.
2 Attach the holder with screws to the wall or a similar location.
3 Hang the wireless remote control on the holder.
4.2 To insert the batteries
The batteries will last for about 1 year.
1 Remove the front cover.
2 Insert both batteries at once.
3 Put back the front cover.