Daikin FTXA25BB/RXA25A - Installation; Opening the Indoor Unit; To Open the Front Panel; To Close the Front Panel

5 Installation
Installation manual
4
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
3P482320-7P – 2019.10
5 Installation
5.1 Opening the indoor unit
5.1.1 To open the front panel
1 Hold the front panel on both sides and open it.
2 Pull down both locks on the back of the front panel.
3 Open the front panel until the support fits into the fixing tab.
a
d
c
b
a Lock (1 on each side)
b Backside of the front panel
c Fixing tab
d Support
5.1.2 To close the front panel
1 Lift the front panel slightly and remove the support from the
fixing tab.
a
b
c
a Backside of the front panel
b Fixing tab
c Support
2 Close the front panel.
3 Gently press the front panel down until it clicks.
5.1.3 To remove the front panel
INFORMATION
Remove the front panel only in case it MUST be replaced.
1 Open the front panel. See "5.1.1 To open the front
panel"[44].
2 Open the panel locks located on the back side of the panel
(1on each side).
a a
a Panel lock
3 Push the right arm lightly to the right to disconnect the shaft
from the shaft slot on the right side.
a
c
b
a Arm
b Shaft
c Shaft slot
4 Disconnect the front panel shaft from the shaft slot on the left
side.
a
c
b
a Arm
b Shaft slot
c Shaft
5 Remove the front panel.
6 To re-install the front panel perform the steps in the opposite
order.
5.1.4 To open the service cover
1 Remove 1 screw from the service cover.
2 Pull out the service cover horizontally away from the unit.
a
b
a Service cover screw
b Service cover
5.1.5 To remove the front grille
CAUTION
Wear protective gloves.