To Next PageTo Next PageWhy Daikin Air Conditioner does not operate?
If your Daikin Air Conditioner is not operating and the OPERATION lamp is off, check the following: 1. Ensure that a breaker hasn't been turned OFF or a fuse hasn't blown. 2. Check for any power failures. 3. Verify that batteries are correctly installed in the remote controller. 4. Make sure the timer setting is correct.
What to do if Daikin Air Conditioner power cord is abnormally hot or damaged?
If the power cord of your Daikin Air Conditioner is abnormally hot or damaged, turn the breaker OFF and call the service shop.
Why Daikin FTXS35D2(3)VMW(L) Air Conditioner operation stops suddenly and OPERATION lamp is on?
If your Daikin Air Conditioner operation stops suddenly while the OPERATION lamp is on, it will automatically resume operation in about 3 minutes.
General| Brand | Daikin |
|---|---|
| Model | FTXS35D2(3)VMW(L) |
| Category | Air Conditioner |
| Language | English |
Important safety instructions and warnings for operating the air conditioner.
Identifies and describes the components of the indoor and outdoor units.
Guides on setting up the remote controller and its batteries before use.
Explains how to select and start different operating modes like AUTO, DRY, COOL, HEAT, FAN.
Details on how to adjust horizontal flaps and vertical louvers for optimal air distribution.
How to activate and cancel the POWERFUL mode for quick cooling or heating.
Instructions for reducing outdoor unit noise for quiet operation, typically at night.
Explains the ECONO mode for energy-efficient operation by limiting power consumption.
How to use the infrared sensor for automatic operation adjustments based on human presence.
Guides on setting ON and OFF timers for automatic unit control.
Information regarding the operation of multi-system units and priority room settings.
General instructions for cleaning indoor, outdoor units, and the remote controller.
Detailed steps for cleaning and replacing air filters and photocatalytic filters.
Common issues and checks to perform before calling a repair person.
How to use the remote controller to diagnose system faults using error codes.
