40
System control via Smart Control System control via Smart Control
To connect the wireless LAN connecting adapter to your home network
The wireless LAN connecting adapter can be connected to your home network by means of:
• Simple connection (WPS connection), if there is a WPS button on the router.
• Access point connection (AP connection), if there is no WPS button on the router.
Simple connection (WPS connection)
If there is a WPS button on your Wi-Fi router, please follow the below steps.
1. While operation is stopped, press and hold
the button for 5 seconds.
• “ ” appears on the LCD.
• “
” (SP menu) blinks.
2. Press or and select SP menu .
3. Press to conrm the selected setting.
• “ ” blinks briey.
• The DAIKIN EYE lamp orange blinks
more quickly.
4. Press the WPS button on your communication
device (e.g. router) within approximately one
minute. Please refer to the manual of your
communication device.
• While the wireless LAN connection adapter is connecting, the DAIKIN EYE lamp changes
from orange to red and blinks. If the connection is successful, the DAIKIN EYE lamp blue
blinks. If you fail to connect, refer to NOTE.
5. Press to return to the default screen.
6. Connect your smart phone to your home
network.
7. Open the Home screen of the DAIKIN Mobile
Controller application. The air conditioner will
be listed there (Fig. 1).
Display
Fig. 1
NOTE
Note on simple connection (WPS connection)
• If you fail to connect (the DAIKIN EYE lamp red continues to blink), repeat steps 1-5.
Alternatively, try connecting via your device directly. Please refer to “Access point connection (AP connection)”.
Page 41
01_EN_3P705032-11D.indd 4001_EN_3P705032-11D.indd 40 06-Feb-24 2:20:00 PM06-Feb-24 2:20:00 PM
To Next Page