5
Read Before Operation Read Before Operation
Names of Parts
Indoor Unit
List of lamps
• The lamp colour changes according to the operation.
Lamp Colour State Description
DAIKIN EYE operation lamp
Red/Blue Lights up
AUTO operation
Green Lights up
DRY operation
Blue Lights up
COOL operation
Red Lights up
HEAT operation
White Lights up
FAN operation
Depends on
operation mode
Blinks Check the error code.
Red Blinks
While operation is stopped, Wireless LAN connecting adapter is enable.
Blue Blinks
While operation is stopped, Wireless LAN connecting adapter is connected.
TIMER lamp
Orange Lights up
TIMER is set.
MOLD PROOF lamp
Green Lights up
MOLD PROOF operation
HOME LEAVE lamp
Green Lights up
HOME LEAVE operation
Streamer air inlet
• Air inlet for streamer operation.
Air inlet
Air outlet
Upper-Air outlet
Lower-Air outlet
Front panel
Louvres (vertical blades)
• The louvres are inside of the air outlet.
Flap (horizontal blade)
Room temperature sensor
and Room humidity sensor
(inside)
Left side of the unit
•
Sense air temperature around the unit.
Right side of the unit
• Sense air temperature and humidity
around the unit.
Air inlet (left/right)
ATTENTION
If you nd that the lamps of the indoor unit are too bright, adjust lamp
brightness to personal preference, or turn OFF the display.
Display
Signal receiver
• It receives signals from
the remote controller.
• When the unit receives a signal,
you will hear a beep sound.
Case Sound type
Operation start beep-beep
Setting change beep
Operation stop long beep
MOLD PROOF lamp (Green)
HOME LEAVE lamp (Green)
TIMER lamp (Orange)
DAIKIN EYE operation lamp
(Multi-colour)
• The lamp colour changes according to
the operation. See “List of lamps”.
01_EN_3P705032-11D.indd 501_EN_3P705032-11D.indd 5 06-Feb-24 2:19:21 PM06-Feb-24 2:19:21 PM
To Next Page