11
DRAIN
GUIDE
ADAPTOR
HOLDER
STEP 4 - Unscrew the Heat Exchanger from the other Side
Panel.
SIDE
PANEL
HEAT
EXCHANGER
STEP 2 - Remove the Drain Guide.
STEP 3 - Unscrew the Adaptor Holder that is connected to
the Side Panel and Heat Exchanger Distributor, then
remove the Adaptor Holder.
INTERCHANGEABLE HEAT EXCHANGER PIPING DIRECTION GUIDE LINE
The simulation below is based on FCU FWC-G Unit. From right piping direction to left piping direction.
To perform this simulation, please seek advice from the trained staff.
This simulation required minimum of two trained servicemen.
! WARNING
Changing the original HEAT EXCHANGER PIPING DIRECTION will cause performance drop of 15% to 20%.
STEP 1 - Remove the Drain Pan.
DRAIN PAN
DRAIN PAN
To Next Page
Loading...
