13
English
■ Airflow selection
• Make airflow selection according to what suits you.
When setting the airflow selection switch to .
• Unit automatically decides the appropriate blowing pattern depending on the operation
mode/situation.
When setting the air outlet selection switch to .
• Regardless of the operation mode or situation, air blows from the upper air outlet.
• Use this switch when you do not want air coming out of the lower air outlet. (While sleeping etc.)
CAUTION
Mode Situation Blowing pattern
COOL
• When the room has become fully
cool, or when one hour has
passed since turning on the unit.
• So that air does not come into direct
contact with people, air is blown upper air
outlet, room temperature is equalized.
• At start of operation or other times
when the room is not fully cooled.
• Air is blown from the upper and lower air
outlets for high speed cooling during COOL
operation, and for filling the room with
warm air during HEAT operation.
HEAT
• At times other than below.
(Normal time.)
• At start or when air temperature is
low.
• So that air does not come into direct
contact with people. Air is blown upper air
outlet.
• Do not try to adjust the flap by hand.
• When adjusting by hand, the mechanism may not operate properly or condensation may drip
from air outlets.
01_EN_3P257979-1A.fm Page 13 Tuesday, March 3, 2015 3:09 PM
To Next Page
Loading...
