EDUS39-600-F6 Installation
FXAQ-M 27
(3) Place the drain plug and the pipe insulation to the right side
(7) Hook the indoor unit onto the installation panel. (Refer to Fig. 9)
• Placing buffering material between the wall and the indoor unit at this time will make work easier.
For bottom-right and back-right piping
• Pass the drain hose and the refrigerant piping to the wall.
(8) Pass power supply wiring and ground wiring threaded through conduit. and remote controller wiring
through the wiring guide in through the back of the indoor unit and to the front. For connecting the conduit to
the unit, see Section 8-1, HOW TO CONNECT WIRINGS.
Drain plug
Insulating tube
Fig. 8
Do not place lubricant (refrigerant oil) when inserting.
This may cause deterioration and water leaks.
Insert using a hexagon wrench (4mm).
Make sure
there are
no gaps.
Refrigerant piping
Be sure to pass all wires through
the wiring guide.
Tab
(There are 2 places.)
Wiring (locally procured)
Transmission wiring, Remote controller wiring
Wall
Installation panel
(accessory) (1)
Front panel
Front grill
Service lid
Place buffering material
Power supply wiring,
Ground wiring
Conduit
Hook the indoor unit hook onto the installation panel (1).
Fig. 9
To Next Page
Loading...
