UNIT1
(Plasma ioniser)
UNIT2
(Streamer unit)
* Remove dirt from recesses
with a cotton swab, etc.
Wear rubber
gloves.
19
Cleaning of UNIT1 and UNIT2
Time for
cleaning
UNIT1:
If the “UNIT1” lamp lights
UNIT2:
Once every 3 months or if
the “UNIT2” lamp lights
Cleaning
method
Soak, drain and dry
Wipe
If marking is a concern, clean the unit even if the “UNIT1” and “UNIT2”
lamps do not light.
For details on removing and attaching each part,
see
Page 17.
►
.
1) Ionising frame
4) Streamer unit
2) Ionised wire (rear) 3) Opposing pole
plates
Procedure
UNIT1
1) Ionising frame 2) Ionised wire 3) Opposing pole plates
Remove the parts.
Page 17, 18.
►
Page 18.
►
Use a vacuum cleaner to remove the
dust.
Soak in lukewarm water or water.
(About 1 hour)
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Wear rubber
gloves.
Wipe
For details, see 1) and
2) below.
Wear rubber
gloves.
Rub
Rinse in running water and drain.
Dry in a well-ventilated, shaded
place. (About 1 day)
Attach the parts.
Page 17, 18.
►
Page 18.
►
1) Ionising frame (Remove dirt after soaking but before drying.)
Remove dirt from plastic parts with a soft piece of cloth.•
Use a cotton swab, etc. to wipe away dirt in recesses and places where fi ngers do not fi t.•
Do not leave any lint from cleaning cloths behind. Lint may lead to malfunctions.•
01_EN_3P276413-1B.indd 1901_EN_3P276413-1B.indd 19 5/11/2011 9:46:07 AM5/11/2011 9:46:07 AM
To Next Page
Loading...