Daikin Perfera RXM R Series - Page 187

3 | Components
Service manual
187
RXM20~71R + ARXM25~71R + FTXM20~71R + ATXM25~50R +
FVXM25~50A
Split New Perfera R32
ESIE20-11 – 2021.01
Class 50~71 indoor unit
1 Connect the wiring harness to the swing raster motor.
2 Install the gear on the swing raster motor shaft.
3 Install the swing raster motor (and gear) on the correct location on the
bracket.
a
c
a b
a Screw (swing raster motor fixation)
b Swing raster motor
c Gear
4 Guide the rod inside the bracket to the correct location. Make sure that the
teeth of the rod are properly fitted on the gear.
5 Install and tighten the 2 screws to fix the swing raster motor to the bracket.
6 Install the swing raster motor assembly on the correct location on the indoor
unit while guiding the rod inside the swing raster compartment.
7 Install the 2 screws to fix the swing raster motor assembly. Do NOT yet tighten
the screws.
e
d
ca
bc
a Swing raster motor cover
b Swing raster motor assembly
c Screw (swing raster motor assembly)
d Fan guard
e Swing raster motor rod
8 Connect the swing raster motor rod to the swing raster shaft using soft tools.
9 Tighten the 2 screws to properly fix the swing raster motor assembly.