What to do if Daikin RXN50CXV1G shows A5?
If your Daikin Air Conditioner is showing the A5 error, here are some things you can check: 1. Make sure the air passage isn't blocked. 2. Inspect the intake air filter. 3. Check for dust on the indoor coil. 4. Examine the wiring and piping. 5. Inspect the EXV. 6. Check the indoor coil and room sensor resistance values. 7. Verify the refrigerant level.
What to do if Daikin RXN50CXV1G shows U4?
If your Daikin Air Conditioner displays the U4 error code, you can try the following troubleshooting steps: 1. Check the connection wires between the indoor and outdoor units. 2. Check the voltage of the signal terminal. 3. Manually rotate the indoor fan to check for obstructions. 4. Check the power supply waveform.
How to troubleshoot E5 error on Daikin RXN50CXV1G Air Conditioner?
To troubleshoot an E5 error on your Daikin Air Conditioner: 1. Check the connection on the discharge pipe sensor. 2. Check the discharge pipe sensor resistance value. 3. Inspect the EXV. 4. Check the refrigerant line for blockages or shortages.
How to troubleshoot Daikin RXN50CXV1G Air Conditioner error H6?
To troubleshoot an H6 error on your Daikin Air Conditioner, you can try these steps: 1. Check for a short circuit. 2. Check the electrolytic capacitor voltage. 3. Check the compressor harness wire. 4. Check with inverter checker.
How to troubleshoot Daikin RXN50CXV1G Air Conditioner error F6?
To troubleshoot an F6 error on your Daikin Air Conditioner, you can try: 1. Checking the installation space. 2. Checking the outdoor fan. 3. Checking the EXV. 4. Checking the coil sensor.
What to do if Daikin RXN50CXV1G shows error A1?
If your Daikin Air Conditioner is displaying the A1 error, you can: 1. Check the connector connection. 2. Replace the indoor PCB.
How to fix E1 error on Daikin RXN50CXV1G?
To address an E1 error on your Daikin Air Conditioner: 1. Restart the system. 2. Replace the outdoor PCB. 3. Ensure the unit is properly grounded. 4. Check the power supply waveform.
What to do if Daikin RXN50CXV1G shows H0 error?
If your Daikin Air Conditioner is showing the H0 error, you should: 1. Check the reactor connection. 2. Check the compressor connection. 3. Measure the resistance value between the reactor terminals. 4. Measure the resistance value between the compressor terminals.
What to do if Daikin RXN50CXV1G Air Conditioner shows J3 error?
If your Daikin Air Conditioner is showing the J3 error, you should: 1. Check the sensor connection. 2. Check the sensor resistance value. 3. Check the indoor coil sensor resistance value.
Defines the allowable operating temperature limits for cooling and heating.
Provides instructions and diagrams for proper unit installation procedures.
Detailed tables of cooling and heating capacities at various conditions.
Guidelines for regular checks and cleaning of unit components.
Explains LED indicators and beep codes for status and fault identification.
Steps to diagnose errors using the remote control and referencing error code tables.
General| Cooling Capacity | 5.0 kW |
|---|---|
| EER | 3.21 |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 13 kg |
| Type | Split System |
To Next Page