Need help?Do you have a question about the Daikin RXQ26AMYM and is the answer not in the manual?
General| Type | Inverter |
|---|---|
| Outdoor Unit Noise Level | 52 dBA |
| Energy Efficiency Ratio (Cooling) | 3.5 |
| Energy Efficiency Ratio (Heating) | 4.0 |
| Outdoor Unit Dimensions (HxWxD) | 320 mm |
Explains the severity and probability of warnings and symbols used in the manual.
Covers general safety guidelines for installation, including electrical shock and contact hazards.
Provides general guidelines for selecting a suitable installation site and environmental considerations.
Specifies requirements for unit installation, including leveling and foundation considerations.
Guides on selecting pipe sizes for different connection points based on capacity.
Outlines maximum allowable pipe lengths, level differences, and branching rules.
Shows piping layouts and limitations for systems with VRV and RA indoor units.
Details precautions for connecting piping between multiple outdoor units using kits.
Provides crucial advice on brazing techniques, including nitrogen purging and avoiding flux.
Outlines the standard procedure for leak testing and vacuum drying before electrical installation.
Describes leak test and vacuum drying after electrical installation, including special settings.
Details vacuum and pressure leak testing procedures and leak detection solutions.
Explains the process of removing moisture from the system using vacuum pumps.
Specifies requirements for insulating refrigerant piping after leak testing and vacuum drying.
Covers essential safety and installation precautions for electrical wiring by qualified electricians.
Details electrical safety device requirements and wiring sizing based on applicable legislation.
Explains how to route and connect transmission wiring for single and multi-outdoor unit systems.
Details the procedures and precautions for performing system test operations.
Provides a list of malfunction codes and their corresponding corrective actions.
Details steps to check maximum refrigerant concentration and necessary actions.
Provides service precautions for units, including static electricity discharge and EL.COMPO.BOX handling.
Details safety precautions for service, EL.COMPO.BOX removal, and piping work.
Details steps to check maximum refrigerant concentration and necessary actions.
To Next Page
