To Next PageTo Next PageWhat to do if Daikin RXYQ120TTJU system does not operate at all?
First, check for a power failure and wait until the power is restored. If the power failure happened during operation, the system will automatically restart once the power supply returns. Also, check if a fuse has blown and turn off the power supply. Check if the breaker is blown and turn the power on with the breaker switch in the OFF position.
Why Daikin RXYQ120TTJU system stops soon after starting the operation?
The system might be stopping soon after starting because the air inlet or outlet of the outside or indoor unit is blocked by obstacles. Remove any obstacles to ensure good ventilation. Also, check if the remote controller display shows “Time to clean filter & element” and clean the air filter or element.
Why is my Daikin RXYQ120TTJU Air Conditioner operating, but cooling or heating is insufficient?
Insufficient cooling or heating may be due to blocked air inlets or outlets on the outside or indoor unit. Make sure to remove any obstacles to ensure proper ventilation. Also, check if the remote controller displays “Time to clean filter & element” and clean the air filter or element. Finally, verify the temperature setting.
How to stop direct sunlight entering the room during Daikin Air Conditioner cooling operation?
To prevent direct sunlight from entering the room during cooling operation, use curtains or blinds.
How to prevent open doors or windows while using Daikin RXYQ120TTJU?
Shut doors and windows to prevent wind from coming in.
General| Brand | Daikin |
|---|---|
| Model | RXYQ120TTJU |
| Category | Air Conditioner |
| Language | English |
Explains the meaning of DANGER, WARNING, CAUTION, and NOTE symbols used throughout the manual.
Details essential safety warnings for DANGER and WARNING levels, covering fire, toxic gas, refrigerant leaks, and electrical hazards.
Provides cautions regarding improper use, water exposure, and operational conditions to prevent minor injury or damage.
Details safety requirements for installation sites, electrical work, operating sound, and proper drainage.
Provides step-by-step instructions to reset the filter indicator after cleaning or replacing the filter.
Explains how error codes are displayed and advises contacting the dealer for specific error situations.
Addresses issues like delayed start-up, central control interference, and intermittent stopping due to noise.
Provides steps to take for malfunctions like safety device activation, water leaks, or non-responsive buttons.
Guides on how to troubleshoot if the system does not operate, stops after starting, or has insufficient cooling/heating.
