SiBE121021_C SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
Operation Manual 279
English 10
PROGRAMMING TIME
TIMER RESERVE
TIMER CANCEL
For example.
1
2
3
4
NOTES
For Heat pump system
Outdoor unit
Indoor unit
TIMER MODE START/
STOP
Press the TIMER MODE START/STOP
button several times and select the
mode on the display.
The display flashes.
For setting the timer stop .... “ ”
For setting the timer start .... “ ”
Press the PROGRAMMING TIME
button and set the time for stopping
or starting the system.
When this button is pressed, the
time advances by 1 hour.
When this button is pressed, the
time goes backward by 1 hour.
Press the TIMER OFF button to cancel
programming. The display vanishes.
When the timer is
programmed to stop
the system after 3
hours and start the
system after 4
hours, the system
will stop after 3
hours and then 1
hour later the
system will start.
• When the timer is programmed to stop the
system after 3 hours and start the system
after 4 hours, the system will stop after 3
hours and then 1 hour later the system will
start.
• After the timer is programmed, the display
shows the remaining time.
HOW TO SET MASTER
REMOTE CONTROLLER
(For VRV system)
• When the system is installed as shown
below, it is necessary to designate the
master remote controller.
When one outdoor unit is connected with
several indoor units.
One of these remote controllers needs
to be designated as the master remote
controller.
Press the TIMER RESERVE button.
The timer setting procedure ends.
The display or changes from flashing light to
a constant light.
To Next Page
Loading...
Need help?
General
