To use ON TIMER operation
1. Press “ON TIMER button”.
is displayed.
blinks.
• Check that the clock is correct. If not, set the clock to the
present time.
2. Press “TIMER Setting button” until the time
setting reaches the point you like.
• Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press “ON TIMER button” again.
• The TIMER lamp lights up.
To cancel ON TIMER operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
(Example)
Combined
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
4
2
1, 3
ATTENTION
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
17
To Next Page
Loading...