Daikin VRV - Start up after a long stop; What to do when stopping the system for a long period; DISPOSAL REQUIREMENTS; WIRING DIAGRAM

Si30-408 List of VRV Unit Models
Introduction 9
2.2.2 Nomenclature (New indication)
Indoor Unit
BS Unit (Only Necessary for Heat Recovery System)
Power supply symbol
VE : Single phase 220 to 240V, 50Hz : 220V, 60Hz
V1 : Single phase 220 to 240V, 50Hz
Indicates major design category
Capacity Indication
Conversion to horsepower:
20 : 0.8 HP 50 : 2.0 HP 125 : 5 HP
25 : 1 HP 63 : 2.5 HP 200 : 8 HP
32 : 1.25 HP 80 : 3.2 HP 250 : 10 HP
40 : 1.6 HP 100 : 4 HP
Refrigerant : R410A
No indication : R22
Type of unit
C : Ceiling mounted cassette type (Double flow)
Z : Ceiling mounted cassette type (600×600 Multi flow)
F : Ceiling mounted cassette type (Multi flow)
K : Ceiling mounted cassette corner type
S : Ceiling mounted built-in type
M : Ceiling mounted duct type
H : Ceiling suspended type
A : Wall mounted type
L : Floor standing type
N : Concealed floor standing type
D : Slim ceiling mounted duct type
U : Ceiling suspended cassette type (Connection unit series)
Indicates that this is VRV system indoor unit.
C 40 VE MQ
FX
(V2286)
V1 : Single phase 220 to 240V, 50Hz
Indicates major design category
Capacity Indication (Connectable total indoor unit capacity)
100 : Total indoor unit capacity less than 100
160 : Total indoor unit capacity 100 or more but less than 160
250 : Total indoor unit capacity 160 or more but less than 250
Refrigerant : R410A
No indication : R22
Indicates that this is a BS unit.
BSV M V1Q 100
(V2287)