13
Clean and maintenance
Clean lter
1
Open panel
Pull out the panel to a certain
angle as shown in the g.
3
Clean lter
● Use dust catcher or water to
clean the filter.
● When the filter is very dirty,
use the water (below 45ºC )
to clean it, and then put it in a
shady and cool place to dry.
2
Remove lter
Remove the lter as
indicated in the g.
4
Install lter
Install the lter and then close the
panel cover tightly.
WARNING
■ The filter should be cleaned every three months. If there is much dust in the
operation environment, clean frequency can be increased.
■ After removing the filter, do not touch fins to avoid injury.
■ Do not use fire or hair dryer to dry the filter to avoid deformation or fire
hazard.
To Next Page
Loading...
