Need help?Do you have a question about the Daking Audio Mic Pre II and is the answer not in the manual?
General| Type | Microphone Preamplifier |
|---|---|
| Polarity Reverse | Yes |
| Connectors (Input) | XLR |
| EIN | -128dB |
| Phantom Power | 48V |
| High-Pass Filter | 12dB/octave |
| Connectors (Output) | XLR |
Follow all instructions, heed warnings, protect from liquids, clean with dry cloth, ensure ventilation.
Lists the components provided with the Daking Audio Mic Pre II, including the unit, power supply, and cables.
Variable filter from 12Hz to 200Hz to remove unwanted low frequencies and rumble.
Controls the input signal gain, adjust to achieve a good signal level without overload.
1/4" front panel input for instruments like guitar, bass, or keyboards.
Reverses signal phase at the XLR input for checking coherence or compensating mis-wiring.
Engages a 20dB attenuator to handle very hot input signals and prevent distortion.
Provides 48V phantom power for condenser microphones; use with quality, good-condition cables.
True VU meter with 300ms averaging, peak indicator, and +23dBu overload indicator.
Balanced XLR inputs/outputs and 1/4" TRS outputs, wired in parallel for flexibility.
Connection port for the included power supply unit. Route cables away from traffic.
To Next Page