MONEY-BACK GUARANTEE Dalen
®
is proud of the extraordinary quality of this product. Should you be dissatisfied with the product’s quality within 90 days of purchase, you may return it to
Dalen
®
for a full refund of your purchase price. Please enclose your dated cash register receipt and a short note explaining your concerns. This limited warranty does not extend to product
damage due to accident, improper use, everyday wear and tear, or the cost of other materials used in the project, labor costs, etc.
PN5398
Dalen Products, Inc., 700 Dalen Lane, Knoxville, TN 37932 • DalenProducts.com
Vertical Trellis Kit
ASSEMBLY INSTRUCTIONS
1. Unpack contents and ensure that you have
the following pieces:
• One (1) Trellis Netting
• Ten (10) 22" Trellis Support Poles
• Five (5) Straight Connectors
• Two (2) A Connectors
• Two (2) Stakes
• Two (2) 5’ Rope
2. Insert two trellis support poles into each straight
connector to create five poles, each approximately
45" long. Ensure the ends with points are facing
out.
3. Insert two of the 45" poles into the bottom
receivers of the A connector, creating the vertical
supports. Repeat for the second A connector.
4. Use the remaining 45" pole as the horizontal cross
bar. Insert each end of the crossbar into the open
fork of the A connectors.
5. Spread apart the vertical supports of the A
connectors to create a stable structure
approximately 28". Push the vertical supports into
the ground for maximum stability.
6. Unfold the netting and drape it over the crossbar
so that the shorter side runs across the crossbar.
Center the netting so that equal amounts hang on
both sides of the crossbar.
7. Use the loose ends of the netting to tie the netting
to all four vertical supports. Be sure to pull the
netting tight when tying for best support.
8. Tie a loop in one end of the rope. On one side,
attach it to the hook at the peak of the A-frame.
9. Drive one 6” stake into the ground approximately
3 feet out from the frame and tie the other end of
the rope to it.
10. Repeat with the second stake and piece of rope
on the other side.
28"
Trellis Netting
22"
Support
Pole
A
Connector
Straight
Connector
Stake
Rope
3'
3'
To Next Page
Need help?
General