DAM MAD FSX - MAD FSX Receiver Operation Instruction; Receiver Power Controls; Receiver Volume and Vibration; Programming Bite Indicator to Receiver



®
FSX RECEIVER

➊

➋

➌

There are 4 volume levels that can be chosen by pushing the volume button multiple times.
One can choose between the settings “low”, “medium”, “high” and the unique vibration mode.
➍

b) Micro LED’s that indicate which of the bite indicators has a “run”.
c) Key ring for securing the receiver to a key chain or a chord.

The bite indicators and the receiver can be programmed very easily by setting the dip switch
systems to correspond with each other. Here is how it works:

You nd the dip switch system in the battery
compartment of the bite indicator.
The rst 4 dip switches are meant for coding the
alarm with the receiver. Always make sure to keep
the rst 4 dip switches of alarm and receiver in
the same position so that they are paired.
The last 4 dip switches are to change the color of LED on the alarm.
These are the different settings for programming the colors:
All dip down = Red color
5th dip up = Green color
6th dip up = Yellow color
7th dip up = Blue color

You nd the dip switch system in the battery compartment
of the receiver.
Always make sure to keep the 4 dip switches of receiver
and the rst 4 switches of the alarm in the same position
so that they are paired.

The bite alarms are designed to function during all kinds of weather types, even heavy rain fall.
This does not mean that the alarms are waterproof! Do not drop the alarms or the receiver in the
water because it can damage the circuit. After heavy rain or damp conditions, always leave the
alarms and receiver dry in a warm place. This will increase the life time off the MAD FSX set.
The Indicators are designed to be shed in a “free run” way. We strongly urge you to NOT use the
bite alarms with methods of shing where the line cannot run of the reel, in other words: where
the drag function is almost or completely disabled. Although the design of the bottom screw part is
extremely stable, it cannot cope with extreme pressure on it.
When the alarms will not be used for a longer period of time, make sure to take out the batteries at
all times. Damage caused by leaking batteries will not be compensated!