EasyManua.ls Logo

DANA SPICER TE27 User Manual

DANA SPICER TE27
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Service Manual
Powershift Transmission
TE27 & TE32 4-Speed Long Drop
with Full Flow Control Valve
TSM-0064
August 2012
80-1070 Rev 5/12/2014
Question and Answer IconNeed help?

Do you have a question about the DANA SPICER TE27 and is the answer not in the manual?

DANA SPICER TE27 Specifications

General IconGeneral
BrandDANA
ModelSPICER TE27
CategoryMicrophone system
LanguageEnglish

Summary

Towing or Pushing

Introduction

Foreword

Brief introduction to the manual's purpose and scope.

Safety Precautions

Essential safety guidelines to prevent injury and damage during service.

Specifications

Identification Tag

Details on locating and understanding the unit's identification plate.

General Specifications

Key physical and operational characteristics of the transmission.

Hydraulic Cooler Lines Specifications

Specifications for hydraulic cooler lines, including diameter and pressure.

Pressure and Temperature Specifications

Critical pressure and temperature parameters for transmission operation and troubleshooting.

Electrical Specifications

Maintenance

Sump Preheaters

Preheating the transmission fluid before engine startup.

Filters

Service intervals for oil filter elements.

Clutch Calibration

Procedure for performing automatic clutch calibration.

Lubricants

Recommended lubricants and their viscosity specifications.

Maintenance Intervals

Daily and periodic maintenance checks and service intervals.

Normal Oil Change Interval

Procedure and interval for normal transmission oil and filter changes.

Extended Oil Change Interval

Considerations for extended oil service life using synthetic fluids.

Servicing Machine After Component Overhaul

Automatic Calibration Procedure

Introduction

Overview of the APC200 firmware's automatic calibration function.

Entering Automatic Calibration Mode

Steps to access the automatic transmission calibration mode.

Performing Automatic Calibration

Conditions and steps required to perform the automatic calibration.

Troubleshooting

Common issues and troubleshooting steps for calibration errors.

Heating Up the Transmission Using 'HEAT'-Mode

Procedure to heat the transmission using the 'HEAT'-mode for calibration.

Calibration Condition Messages and Errors

Explains common calibration messages and error codes.

Drive Plate Installation

Transmission to Engine Installation

External Plumbing Installation

Cooler & Filter Line Specifications

Specifications for external cooler and filter lines.

Speed Sensor Installation

Temperature Sensor Installation

Related product manuals