Danby DAC5277EE - Page 5

Energy-Saving Tips
Your Room Air Conditioner is designed to be
highly efficient in energy savings. Follow these
recommendations for greater efficiency.
1. Select thermostat setting that suits your
comfort needs and leave thermostat at that
chosen setting.
2. The filter is very efficient in removing airborne
particles. Keep air filter clean. Normally, filter
should be cleaned every 2 weeks. More
frequent cleaning may be necessary depending
on outdoor and indoor air quality.
3. Use drapes, curtains, or shades to keep
direct sunlight from heating room, but DO NOT
obstruct the air conditioner. Allow air to circulate
around the unit without obstruction.
4. Start your air conditioner before outdoor air
becomes hot and uncomfortable. This avoids an
initial period of discomfort while unit is cooling
off the room.
5. When outdoor temperatures are cool enough,
use"^" (HIGH FAN), " " (MED FAN) or
”^"(LOW FAN) only (depending on your
model).This circulates indoor air,providing
some cooling comfort ,and utilizes less
electricity than when operating on a cooling
setting.
Window Installation
XM
Electric Shock Hazard
To avoid the possibility of personal
m§
injury, disconnect power to the unit
before installing or servicing.
Tools Needed for Window Installation
Screw Drivers: Both Phillips and flat head
Power Drill: 1/8 inch(3.2mm)diameter drill bit
Pencil
Measuring Tape
Scissors
Carpenters Level
Adjustable Wrench
A CAUTION A
To avoid installation/operation difficulties,
read these instructions thoroughly.
Your Room Air Conditioner is designed for easy
installation in a single or double-hung window.
NOTE: This unit is NOT designed for vertical (slider
type) windows and/or through-the-wall
applications. N OTE: Save the shipping carton and
packing materials for future storage or transport of
the unit. Remove from carton, the plastic bag
containing the installation hardware kit necessary for
the installation of your air conditioner. Please check
the contents of hardware kit agaist the corresponding
model check list, prior to installation of the unit.
See Fig. 1
Fig. 1 Installation Hardware
(O) Flat Washers (8)
3/4” (19.1mm)
Screws (8)
1/4” (6.4mm)
Screws{18)
Top Channel (1)
Mounting
Brackets (2)
Shutter Brackets (2)
Side Curtain RH (1) i
Side Curtain LH (1)
)£) Foam Seal
Levelling Legs (2)
4